Displaying Tester Usage History for Vehicle Connected to M-MDS
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off or on).
- Perform the following procedure using the M-MDS.
- Press [Start] for the vehicle identification.
- Press the [Toolbox] tab.
- Press the [Diagnosis] icon or the [Work Support] icon.
- Press [Run] for Tester usage history.
- Verify the tester usage history according to the directions on the screen.