Trunk End Trim Removal/Installation
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
- Remove the trunk covering. (See TRUNK COVERING REMOVAL/INSTALLATION .)
- Remove the trunk board. (See TRUNK BOARD REMOVAL/INSTALLATION (US) .)
- Partially peel back the weatherstrip.
- Pull the trunk end trim in the direction of the arrow in the order of (1), (2) shown in the illustration while detaching tabs, clips, pins and guides.
- Install in the reverse order of removal.