Snap ring, Ball, Inner Ring, Cage Disassembly Note

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

Place alignment marks on the shaft, inner ring, and cage.
CAUTION:
- To prevent part damage, do not use a punch or similar tool to place alignment marks. Use paint.
Courtesy of MAZDA MOTORS CORP.
Remove the snap ring using snap ring pliers.

Courtesy of MAZDA MOTORS CORP.
Remove the ball, inner ring, and cage from the shaft.
CAUTION:
- When using a hammer and urethane bar or equivalent, be careful not to damage the ball, ball sliding area, and cage.
NOTE:
- If the ball, inner ring, and cage cannot be removed from the shaft, lightly tap the inner ring evenly using a hammer and urethane bar or equivalent, and remove the ball, inner ring, and cage from the shaft.
Wipe off grease on the shaft, ball, inner ring, and cage using a clean cloth.