Clip, Outer Ring Disassembly Note
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Place alignment marks on the shaft and outer ring.
CAUTION:
- To prevent part damage, do not use a punch or similar tool to place alignment marks. Use paint.
 Courtesy of MAZDA MOTORS CORP.
|
- Remove the clip using a screwdriver.
 Courtesy of MAZDA MOTORS CORP.
|
- Remove the outer ring from the shaft.
- Wipe off grease on the outer ring using a clean cloth.