Ball, Inner Ring, Cage, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

Assemble the shaft, inner ring, and cage with the alignment marks aligned.
CAUTION:
- When using the hammer and urethane bar or equivalent, be careful not to damage the ball, ball sliding area, and cage.
NOTE:
- If the ball, inner ring, and cage cannot be assembled to the shaft, lightly tap the inner ring evenly using a hammer and urethane bar or equivalent, and assemble the ball, inner ring, and cage to shaft.
Courtesy of MAZDA MOTORS CORP.
Assemble a new snap ring using snap ring pliers.

Courtesy of MAZDA MOTORS CORP.
Verify that the snap ring is assembled correctly in the groove of the shaft.