Snap Ring, Tripod Joint Disassembly Note

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

To prevent damage to parts, use paint instead of a punch or similar tool to place alignment marks.

Place alignment marks on the shaft and tripod joint.

Courtesy of MAZDA MOTORS CORP.
Remove the snap ring using snap ring pliers.

Courtesy of MAZDA MOTORS CORP.
NOTE:
- If the tripod joint cannot be removed from the shaft, lightly tap the tripod joint evenly using a hammer and urethane bar or equivalent, and remove the tripod joint from the shaft.
CAUTION:
- Be careful not to scratch the roller area when using a hammer and urethane bar or equivalent. Otherwise, the part could be damaged.
Remove the tripod joint from the shaft.
Wipe off grease on the shaft and tripod joint using a clean cloth.