On-vehicle Inspection
WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the battery is fully charged. (See BATTERY INSPECTION (US) .)
- The starter is normal if it rotates smoothly and without any noise when the engine is cranked.
- If the starter does not operate, inspect the following:
- Remove the starter, and inspect the starter unit.
- Inspect the related wiring harnesses and the ignition switch.
- Verify any TCM DTCs to check whether there is a malfunction with the selector lever in determining the shift position. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (ET6A-EL, ET6AX-EL) (US)] .)