LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Automatic Transaxle System (Service Information) (EV6A-El, EV6AX-El)) >> Down Switch Inspection >> Continuity Inspection

Continuity Inspection

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The down switch is built into the selector lever component.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
  2. Remove the following parts:
    1. Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .)
    2. Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .)
    3. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    4. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
    5. Cup holder (See CUP HOLDER REMOVAL/INSTALLATION .)
    6. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    7. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION (US) .)
    8. Rear console bracket No. 1 (See REAR CONSOLE REMOVAL/INSTALLATION (US) .)
  3. Disconnect the selector lever component connector.
    G13176888Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals D and H.
G13176889Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals