Diagnostic Procedure
DTC U0422:68 (INSTRUMENT CLUSTER) DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY BCM DTCs
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [BCM] .) |
| No | Go to the next step. | ||
| 2 | VERIFY IF MALFUNCTIONING LOCATION IS BCM DEPENDING ON REPEATABILITY
|
Yes | Replace the BCM, then go to the next step. (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION .) |
| No | Go to Step 4. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (INSTRUMENT CLUSTER) .) |
| No | DTC troubleshooting completed. | ||