Diagnostic Procedure

DTC U3000:41 [INSTRUMENT CLUSTER] DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	PERFORM DTC INSPECTION AND VERIFY INSTRUMENT CLUSTER MALFUNCTION Clear the DTC for the instrument cluster using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same Pending DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
1		No	Go to the next step.
2	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .)
2		No	DTC troubleshooting completed.