Diagnostic Procedure

DTC U0402:68 [INSTRUMENT CLUSTER] DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY TCM DTCs Retrieve the TCM DTCs using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (FW6A-EL)] .) (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (GW6A-EL )] .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (FW6A-EL)] .) (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (GW6A-EL )] .)
1		No	Go to the next step.
2	DRIVE VEHICLE THEN VERIFY DTCs FOR TCM AGAIN Drive the vehicle at a vehicle speed of 30 km/h {19 mph} or more for 100 s or more. Retrieve the TCM DTCs using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (FW6A-EL)] .) (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (GW6A-EL )] .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (FW6A-EL)] .) (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (GW6A-EL )] .)
2		No	Go to the next step.
3	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the instrument cluster using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Switch the ignition ON (engine off or on) and wait for 20 s or more. Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) Go to the next step.
3		No	Go to the next step.
4	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .)
4		No	DTC troubleshooting completed.