Diagnostic Procedure

DTC B11D4:53 [INSTRUMENT CLUSTER] DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY ALL SYSTEM DTCs Switch the ignition to off. Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the MMDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Are any DTCs other than DTC B11D4:53?	Yes	Repair the malfunctioning part according to the applicable system DTC troubleshooting.
1		No	Go to the next step.
2	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear DTC for the instrument cluster using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the MMDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same Pending DTC present?	Yes	Replace the forward sensing camera (FSC), then go to the next step. (See FORWARD SENSING CAMERA (FSC) REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable system DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .)
3		No	DTC troubleshooting completed.