LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> 6 Grand Touring >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> High-Mount Brake Light Removal/Installation

High-Mount Brake Light Removal/Installation

NOTE:
  • When removing the high-mount brake light, it can be performed smoothly by folding the rear seat back.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Insert a tape-wrapped flathead screwdriver into the gap between the high-mount brake light cover and rear package trim shown in the figure.
    G11544711Courtesy of MAZDA MOTORS CORP.
  3. While pressing the hook A in the direction of the arrow (1) shown in the figure, lift up the high-mount brake light cover in the direction of the arrow (2) shown in the figure to pull out the hooks A from the rear package trim.
    G09788163Courtesy of MAZDA MOTORS CORP.
  4. Move the high-mount brake light cover in the direction of the arrow (1) shown in the figure to pull out the hooks B from the rear package trim.
    G11544713Courtesy of MAZDA MOTORS CORP.
  5. Disconnect the connector.
    G09788165Courtesy of MAZDA MOTORS CORP.
  6. Move the high-mount brake light in the direction of the arrow shown in the figure to detach the high-mount brake light cover tabs from the high-mount brake light.
    G11544715Courtesy of MAZDA MOTORS CORP.
  7. Remove the high-mount brake light.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals