LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> 6 Carbon Edition >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Rear Package Trim Removal/Installation

Rear Package Trim Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Lower the rear seat back.
  3. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    3. Rear seat side back (See REAR SEAT SIDE BACK REMOVAL/INSTALLATION .)
    4. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    5. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    6. High-mount brake light (See HIGH-MOUNT BRAKE LIGHT REMOVAL/INSTALLATION .)
  4. Remove the fasteners.
    G11544586Courtesy of MAZDA MOTORS CORP.
  5. Remove the clips.
    G12236490Courtesy of MAZDA MOTORS CORP.
  6. Pull up the rear package trim in the direction of the arrow (1) shown in the figure while remove the guides, pull the rear package trim in the direction of the arrow (2), and remove it.
    G11544588Courtesy of MAZDA MOTORS CORP.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals