Diagnostic Procedure

ELECTRIC PARKING BRAKE WARNING LIGHT TURNS ON (ELECTRIC PARKING BRAKE, US) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY ALL SYSTEM DTCs Switch the ignition off. Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a DTC inspection using the M-MDS. (See DTC INSPECTION .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [DSC HU/CM (US)] .)
1		No	Go to the next step.
2	DETERMINE IF CAUSE OF MALFUNCTION IS DSC HU/Control Module OR INSTRUMENT CLUSTER Ignition is switched ON (engine off) Does the electric parking brake warning light turn on/off?	Yes	Replace the DSC HU/Control Module. (See DSC HU/CM REMOVAL/INSTALLATION [L.H.D. (US)] .) Perform the repair completion verification.
2		No	Replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) Perform the repair completion verification.
Repair completion verification	VERIFY THAT MALFUNCTION SYMPTOMS DO NOT RECUR AFTER REPAIR Install/connect the part removed/disconnected during the troubleshooting procedure. Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting. Explain to the customer what has been repaired.
Repair completion verification		No	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW (US) .) If the CAN communication is normal, perform the diagnosis from Step 1.