Diagnostic Procedure

ONLY PARTIAL INDICATION ON ACTIVE DRIVING DISPLAY DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY ALL SYSTEM DTCs Perform the DTC inspection. (See DTC INSPECTION .) Are any DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
1		No	Go to the next step.
2	VERIFY PERSONALIZATION FEATURES SETTING Verify the active driving display indication setting. Is the indication setting turned off?	Yes	Turn on the indication setting and verify the operation. Operation is verified: Troubleshooting completed. (Explain the contents of the servicing to the customer.) Operation is not verified: Go to the next step.
2		No	Go to the next step.
Repair completion verification	VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting. (Explain contents of repair to customer)
Repair completion verification		No	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW (US) .) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction is not resolved, replace the active driving display. (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION (US) .)