Diagnostic Procedure

DTC U0433:00 (ACTIVE DRIVING DISPLAY) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY ALL SYSTEM DTCs Switch the ignition off. Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the M-MDS. (See DTC INSPECTION [ACTIVE DRIVING DISPLAY] .) Are any DTCs other than DTC U0433:00 displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)] .) (See DTC TABLE [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))] .) (See DTC TABLE [ACTIVE DRIVING DISPLAY] .) (See DTC TABLE [FORWARD SENSING CAMERA (FSC)] .)
1		No	Go to the next step.
2	VERIFY DTCs AGAIN Clear the DTC for the active driving display using the M-MDS. (See CLEARING DTC [ACTIVE DRIVING DISPLAY] .) Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the M-MDS. (See DTC INSPECTION [ACTIVE DRIVING DISPLAY] .) Is the same DTC displayed?	Yes	Without center display: Go to the next step. With center display: Go to Step 4.
2		No	Go to Step 6.
3	VERIFY CENTER DISPLAY Verify the center display. Is the "Smart city brake support (SCBS) malfunction. Clean the front windshield. Have the vehicle checked by a dealer if this indicator stays on." displayed in the center display?	Yes	Clean the windshield, then go to the next step.
3		No	Go to Step 5.
4	VERIFY IF MALFUNCTIONING LOCATION IS FORWARD SENSING CAMERA (FSC) DEPENDING ON REPEATABILITY Clear the DTC for the active driving display using the M-MDS. (See CLEARING DTC [ACTIVE DRIVING DISPLAY] .) Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the M-MDS. (See DTC INSPECTION [ACTIVE DRIVING DISPLAY] .) Is the same DTC displayed?	Yes	Replace the forward sensing camera (FSC), then go to the next step. (See FORWARD SENSING CAMERA (FSC) REMOVAL/INSTALLATION .)
4		No	Go to Step 6.
5	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the active driving display using the M-MDS. (See CLEARING DTC [ACTIVE DRIVING DISPLAY] .) Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the M-MDS. (See DTC INSPECTION [ACTIVE DRIVING DISPLAY] .) Is the same DTC displayed?	Yes	Replace the active driving display, then go to the next step. (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION .)
5		No	Go to the next step.
6	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [ACTIVE DRIVING DISPLAY] .)
6		No	DTC troubleshooting completed.