DTC P0462-00: Fuel Gauge Sender Unit Circuit Low Input: Notes
DTC P0462:00 PCM (SKYACTIV-G 2.5 - WITH CYLINDER DEACTIVATION) DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P0462:00 |
FUEL GAUGE SENDER UNIT CIRCUIT LOW INPUT |
| DETECTION CONDITION |
- The PCM monitors the fuel level signal and fuel gauge sender unit output voltage from the instrument cluster. If the PCM detects a fuel level or fuel gauge sender unit output voltage that is too low, the PCM determines that the fuel gauge sender unit circuit has a malfunction.
Diagnostic support note
- This is a continuous monitor (CCM).
- The check engine light does not illuminate.
- FREEZE FRAME DATA is not available.
- Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
|
| POSSIBLE CAUSE |
- Fuel gauge sender unit connector or terminals malfunction
- Rear body control module (RBCM) connector or terminals malfunction
- Short to ground in wiring harness between fuel gauge sender unit terminal D and rear body control module (RBCM) terminal 3I
- Fuel gauge sender unit signal circuit and ground circuit are shorted to each other
- Fuel gauge sender unit malfunction
- Rear body control module (RBCM) malfunction
- Instrument cluster malfunction
- PCM malfunction
|
 Courtesy of MAZDA MOTORS CORP.
|