LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2020 >> 6 Sport >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> On-Board Diagnostics (2 Of 3) (SKYACTIVE-G 2.5 (With Cylinder Deactivation)) >> DTC P0451-00: Fuel Tank Pressure Sensor: Sensor Characteristic Malfunction >> Function Inspection Using M-MDS

Function Inspection Using M-MDS

DTC P0451:00 PCM (SKYACTIV-G 2.5 - WITH CYLINDER DEACTIVATION) FUNCTION INSPECTION USING M-MDS

STEP INSPECTION RESULTS ACTION
1 PURPOSE: VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes
  • Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 PURPOSE: RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
- Go to the next step.
3 PURPOSE: VERIFY IF FUEL TANK PRESSURE SENSOR HAS MALFUNCTION  Yes
No Go to the next step.
4 PURPOSE: INSPECTION OF CLOGGING BETWEEN FUEL TANK PRESSURE SENSOR AND FUEL TANK  Yes
No Go to the next step.
5 PURPOSE: VERIFY IF CV SOLENOID VALVE HAS MALFUNCTION  Yes
No Go to the next step.
6 PURPOSE: VERIFY IF FUEL TANK PRESSURE IS STUCK TO EITHER LOW OR HIGH PRESSURE SIDE  Yes
  • The possibility that the fuel tank pressure is stuck to the high pressure side is high.
  • Go to the next step.
No
  • The possibility that the fuel tank pressure is stuck to the low pressure side is high.
  • Go to the troubleshooting procedure to perform the procedure from Step 3.
7 PURPOSE: VERIFY IF MALFUNCTION CAUSE IS FREEZING OF FUEL TANK PRESSURE SENSOR BY VERIFYING AMBIENT TEMPERATURE  Yes
  • The possibility of a malfunction caused by freezing of the fuel tank pressure sensor is high.
  • Go to the troubleshooting procedure to perform the procedure from Step 1.
No Go to the troubleshooting procedure to perform the procedure from Step 2.