Diagnostic Procedure

DTC B11D4:53 (INSTRUMENT CLUSTER) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY ALL SYSTEM DTCs Switch the ignition to off. Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the M-MDS. (See DTC INSPECTION (INSTRUMENT CLUSTER) .) Are any DTCs other than DTC B11D4:53?	Yes	Repair the malfunctioning part according to the applicable system DTC troubleshooting.
1		No	Go to the next step.
2	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear DTC for the instrument cluster using the M-MDS. (See CLEARING DTC (INSTRUMENT CLUSTER) .) Switch the ignition ON (engine off or on) and wait for 10 s or more. Perform a CMDTC self-test using the M-MDS. (See DTC INSPECTION (INSTRUMENT CLUSTER) .) Is the same Pending DTC present?	Yes	Replace the forward sensing camera (FSC), then go to the next step. (See FORWARD SENSING CAMERA (FSC) REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable system DTC troubleshooting. (See DTC TABLE (INSTRUMENT CLUSTER) .)
3		No	DTC troubleshooting completed.