Diagnostic Procedure

DTC U2300:41 (INSTRUMENT CLUSTER) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	PERFORM INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) Using the M-MDS, perform the instrument cluster configuration (using As-Built data). (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) Clear the DTC for the instrument cluster using the M-MDS. (See CLEARING DTC (INSTRUMENT CLUSTER) .) Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION (INSTRUMENT CLUSTER) .) Is the same Pending DTC present?	Yes	Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .)
1		No	Go to Step 3.
2	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the instrument cluster using the M-MDS. (See CLEARING DTC (INSTRUMENT CLUSTER) .) Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION (INSTRUMENT CLUSTER) .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) Go to the next step.
2		No	Go to the next step.
3	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (INSTRUMENT CLUSTER) .)
3		No	DTC troubleshooting completed.