LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> 3 Touring, 4D Sedan, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Drive Selection System) >> Drive Selection Switch Removal/Installation >> Without Electric Parking Brake

Without Electric Parking Brake

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  2. Remove the upper panel. (See UPPER PANEL REMOVAL .) (See UPPER PANEL INSTALLATION .)
  3. Remove the selector lever knob. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
  4. Remove the shift panel. (See SHIFT PANEL REMOVAL/INSTALLATION .)
  5. Remove in the order indicated in the table
  6. Install in the reverse order of removal.
Fig 1: Removing/Installing Drive Selection Switch Parts
G11450709Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals