LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> 3 Touring, 4D Sedan, Standard Trans >> Repair and Diagnosis >> Electrical >> Horns >> Instrumentation/Driver Info >> Horn Removal/Installation

Horn Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the set plate. (See SET PLATE REMOVAL/INSTALLATION .)
  3. Remove the front bumper. (See FRONT BUMPER REMOVAL .) (See FRONT BUMPER INSTALLATION .)
  4. Disconnect the connector.
    Fig 1: Detaching Connector
    G11564705Courtesy of MAZDA MOTORS CORP.
  5. Remove the bolts.
  6. Remove the body ground.
  7. Remove the horn.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals