LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2018 >> 3 Touring, 4D Sedan, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Trunk Side Upper Trim Removal/Installation

Trunk Side Upper Trim Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION .)
    2. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
    3. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  3. Move the tire house trim in the direction of the arrow shown in the figure and peel it back partially until the hooks and clip are detached.
    Fig 1: Moving Tire House Trim
    G11449416Courtesy of MAZDA MOTORS CORP.
  4. Remove the fastener.
    Fig 2: Removing Fastener
    G11449417Courtesy of MAZDA MOTORS CORP.
  5. Pull out the area A of the cargo hook cover and remove the cargo hook cover.
  6. Partially peel back the seaming welt.
  7. Pull the trunk side upper trim in the direction of the arrow in the order of (1), (2), (3) and (4) and remove it while detaching the clips A, clips B and hooks.
    Fig 3: Detaching Clips A, Clips B And Hooks
    G11449418Courtesy of MAZDA MOTORS CORP.
  8. Disconnect the cargo room light connector. (LH only)
  9. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals