Diagnostic procedure

NO. 8 SMART CITY BRAKE SUPPORT INDICATOR LIGHT STAY ON AND MESSAGE "SCBS INSPECTION REQUIRED" IS INDICATED IN DISPLAY (DYNAMIC STABILITY CONTROL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	CONFIRM LASER SENSOR DTC Retrieve the laser sensor DTC using the M-MDS. (See DTC INSPECTION [LASER SENSOR] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [LASER SENSOR] .)
1		No	Go to the next step.
2	CONFIRM DSC HU/CM DTC Retrieve the DSC HU/CM DTC using the M-MDS. (See DTC INSPECTION [DSC HU/CM] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC INSPECTION [DSC HU/CM] .)
2		No	Go to the next step.
3	CONFIRM PCM DTC Retrieve the PCM DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [PCM (SKYACTIV-G 2.5T)] .)
3		No	Retrieve the instrument cluster DTC using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) If any DTCs are present, go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) If there is not a DTC, replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)