Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	RECORD CONFIGURATION DATA Switch the ignition to OFF. Switch the ignition ON (engine off).		Go to the next step.
2	VERIFY DTC TROUBLESHOOTING COMPLETED Using the M-MDS, clear the DTC from the laser sensor. (See CLEARING DTC [LASER SENSOR] .) Using the M-MDS, perform the laser sensor DTC inspection. (See DTC INSPECTION [LASER SENSOR] .) Is the same DTC present?	Yes	Repeat the inspection from Step1. If the malfunction recurs, replace the laser sensor, then go to the next step. (See LASER SENSOR REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE [LASER SENSOR] .)
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.