Diagnostic procedure
ABNORMAL NOISE WHILE DOOR GLASS IS OPENING OR CLOSING (POWER WINDOW SYSTEM) DIAGNOSTIC PROCEDURE
| Noise type | Time of occurrence | Possible cause | Location of noise | Action |
|---|---|---|---|---|
| Clanking noise | Door glass begins to move | Insufficiently tightened installation screw between the door glass and carrier plate. | Between door glass lower edge and carrier plate. | Securely tighten the installation screw. |
| Groaning noise (Sound increases due to use) | While door glass is operating | Vibration caused by wear on the resin part from cable twisting due to use of the power window regulator.
NOTE:
|
Power window regulator | Replace the power window regulator (See FRONT POWER WINDOW REGULATOR REMOVAL/INSTALLATION
.) (See REAR POWER WINDOW REGULATOR REMOVAL/INSTALLATION .) |
| Whining noise | Gear inside power window motor is deformed due to use. | Gear in power window motor | Replace the power window motor (See FRONT POWER WINDOW MOTOR REMOVAL/INSTALLATION
.) (See REAR POWER WINDOW MOTOR REMOVAL/INSTALLATION .) |
|
| Clicking noise (Periodic noise) |