DTC P0768-00; Shift Solenoid No. 4 Circuit Malfunction: Notes

DETECTION CONDITION & POSSIBLE CAUSE

DTC P0768:00	Shift solenoid No. 4 circuit malfunction
DETECTION CONDITION	Under the following condition, the TCM detects the shift solenoid No. 4 circuit malfunction: Battery voltage is 10.5 V or more.
FAIL-SAFE FUNCTION	Set to emergency mode. Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
POSSIBLE CAUSE	Short or open circuit in shift solenoid No. 4 circuit Shift solenoid No. 4 malfunction
SYSTEM WIRING DIAGRAM	Not applicable

DETECTION CONDITION & POSSIBLE CAUSE

DTC P0768:00	Shift solenoid No. 4 circuit malfunction
DETECTION CONDITION	Under the following condition, the TCM detects the shift solenoid No. 4 circuit malfunction: Battery voltage is 10.5 V or more.
FAIL-SAFE FUNCTION	Set to emergency mode. Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
POSSIBLE CAUSE	Short or open circuit in shift solenoid No. 4 circuit Shift solenoid No. 4 malfunction
SYSTEM WIRING DIAGRAM	Not applicable