Diagnostic Procedure

DIAGNOSTIC PROCEDURE DESCRIPTION

Step	Inspection		Action
1	VERIFY INSTRUMENT CLUSTER DTC Using the M-MDS, clear the DTC from the instrument cluster. (See CLEARING DTC [INSTRUMENT CLUSTER (TPMS)] .) Using the M-MDS, perform the instrument cluster DTC inspection. (See DTC INSPECTION [INSTRUMENT CLUSTER (TPMS)] .) Is the same DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
1		No	Go to the next step.
2	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
2	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.