Diagnostic Procedure

DIAGNOSTIC PROCEDURE DESCRIPTION

Step	Inspection		Action
1	INSPECT THE TIRE PRESSURE Inspect the tire pressure when the tires are cold. (See WHEEL AND TIRE SPECIFICATION .) Is the pressure as specified?	Yes	Go to the next step.
1		No	Adjust the tire pressure to the specification when the tires are cold, then go to the next step.
2	VERIFY INSTRUMENT CLUSTER DTC Using the M-MDS, clear the DTC from the instrument cluster. (See CLEARING DTC [INSTRUMENT CLUSTER (TPMS)] .) Using the M-MDS, perform the instrument cluster DTC inspection. (See DTC INSPECTION [INSTRUMENT CLUSTER (TPMS)] .) Is the same DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER (TPMS)] .)
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.