Rear Crossmember Component Installation Note

WARNING:

• Verify that the rear crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle.

1. Assemble the wiring harness clips and connector shown in the figure.
   Fig 1: Locating Rear Crossmember Component Wiring Harness Clips And Connector

   Courtesy of MAZDA MOTORS CORP.
2. Support the rear crossmember component and install the rear crossmember.

Fig 2: Supporting Rear Crossmember With Jack

Courtesy of MAZDA MOTORS CORP.