Indicator light
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Body".
- Select the "EATC Operation Check".
- Select the "Illumination Of All Indicator Lights" from the screen menu.
- Verify the A/C operation check mode according to the directions on the screen.
- Select "Stop" to stop the A/C operation check. (See A/C OPERATION CHECK STOP .)
A/C OPERATION DESCRIPTION
| Step | Air mix actuator | Airflow mode actuator | Blower speed | Magnet clutch | Air intake actuator |
|---|---|---|---|---|---|
| - | 50 % | VENT | OFF | OFF | FRESH |
INDICATOR LIGHT OPERATION DESCRIPTION
| Step | Recirculate switch indicator light | Rear window defroster switch indicator light | A/C switch indicator light |
|---|---|---|---|
| - | Illuminated | Illuminated | Illuminated |