DTC U2300-54; U2300-55 U2300-56 U2300-64; Configuration Errors: Notes
DTC DETECTION DESCRIPTION
| System malfunction location |
- U2300:54: Configuration error (data not received)
- U2300:55: Configuration error (not configured)
- U2300:56: Configuration error (ineffective/non-interchangeable data read)
- U2300:64: Configuration error (error value read)
|
| Detection condition |
- Climate control unit detects configuration data not record or data error
|
| Fail-safe function |
- Sets the configuration value to the following fixed value
- Destination: North_America
- FSC_Types: FOW_and_LDW_and:C
- PTC heater: Not_Equipped
- Rear_vent: Equipped
- ICA_Types: Normal_Type
- Transmission_Types: MT
|
| Possible cause |
NOTE:
- If power from the battery is interrupted, the climate control unit will go into a non-configured state because the memory for the configuration information is erased.
- Normally, the configuration is re-performed within 6 s after the ignition is switched ON (engine off).
- After performing the configuration, DTC U2300:55 will be cleared if the ignition is switched ON (engine off) after the ignition is switched off.
- Module configuration procedure was not completed properly
- Correct data cannot be received from instrument cluster
- Climate control unit malfunction
|
| System wiring diagram |
Not applicable |