Indicator light
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Body".
- Select the "EATC Operation Check".
- Select the "Illumination Of All Indicator Lights" from the screen menu.
- Verify the A/C operation check mode according to the directions on the screen.
- Select "Stop" to stop the A/C operation check. (See A/C operation check stop .)
Operation
| Step | Air mix actuator | Airflow mode actuator | Blower speed | Magnet clutch | Air intake actuator |
|---|---|---|---|---|---|
| - | 50 % | VENT | OFF | OFF | FRESH |
Display
| Step | Temperature (°C {°F}) | Airflow mode | Blower volume | A/C | Recirculate switch indicator light | Fresh switch indicator light | Defroster switch indicator light | Rear window defogger switch indicator light |
|---|---|---|---|---|---|---|---|---|
| - | All indicator displayed | Illuminated | Illuminated | Illuminated | Illuminated | |||