Air intake actuator
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Body".
- Select the "EATC Operation Check".
- Select the "Air Intake Actuator" from the screen menu.
- Verify the A/C operation check mode according to the directions on the screen.
- Select "Stop" to stop the A/C operation check. (See A/C operation check stop .)
Operation
| Step | Air mix actuator | Airflow mode actuator | Blower speed | Magnet clutch | Air intake actuator |
|---|---|---|---|---|---|
| 1 | 0 % | VENT | 5th | ON | Fresh |
| 2 | Recirculate (25 %) | ||||
| 3 | Recirculate (50 %) | ||||
| 4 | Recirculate (75 %) | ||||
| 5 | Recirculate (100 %) | ||||
| 6 | OFF | Recirculate (75 %) | |||
| 7 | Recirculate (50 %) | ||||
| 8 | Recirculate (25 %) | ||||
| 9 | Fresh |
Display
| Step | Temperature (°C {°F}) | Airflow mode | Blower volume | A/C | Recirculate switch indicator light | Fresh switch indicator light | Defroster switch indicator light | Rear window defogger switch indicator light |
|---|---|---|---|---|---|---|---|---|
| 1 | 4 {39} | Displayed | Not illuminated | Illuminated | Not illuminated | Not illuminated | ||
| 2 | ||||||||
| 3 | ||||||||
| 4 | ||||||||
| 5 | Illuminated | Not illuminated | ||||||
| 6 | Not displayed | Not illuminated | Illuminated | |||||
| 7 | ||||||||
| 8 | ||||||||
| 9 |
NOTE:
- After approx. 2 shave elapsed, the operation step moves to the next step.
- When the last step is finished, the operation is repeated from Step 1.
- To prevent super-cooling, the magnetic clutch turns off despite the A/C forced override.