Coupling Component Installation Note
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Clean away the remaining silicone sealant before applying new silicone sealant.
- Install the coupling component before the applied silicone sealant starts to harden.
- Add rear differential oil after the silicone sealant hardens.
- Apply a thin layer of silicone sealant (TB1217C or equivalent) to the contact surfaces of the coupling component and the rear differential.
- Install the coupling component to the differential.
Tightening torque
23-26 N.m {2.4-2.6 kgf.m, 17-19 ft.lbf}