AWD Solenoid Inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery cable.
- Disconnect the AWD solenoid connector.
- Measure resistance between AWD solenoid connector terminals A and B.
Courtesy of MAZDA MOTORS CORP.
- If the resistance is not within the specification, replace the coupling unit.
AWD solenoid resistance
2.2-2.7 ohms
(Rear differential oil temperature at 20°C {68°F})
- Connect the AWD solenoid connector.
- Connect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)