LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (On-Board Diagnostic - AWD System) >> Electronic AWD Control System On-Board Diagnosis [Electronic AWD Control System] >> On-Board Diagnostic (OBD) Test Description >> Snapshot Data Table

Snapshot Data Table

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Snapshot data items are not displayed, according to detected DTC.

-: Not applicable

SNAPSHOT DATA REFERENCE

Snapshot data item Unit Data contents Data read/use method Corresponding data monitor items
AAT °C °F Ambient temperature - -
IC_VPWR V Instrument cluster power supply voltage
  • The AWD CM constantly receives the power supply voltage value of the instrument cluster sent via CAN signal from the instrument cluster.
  • If a DTC is detected, the AWD CM records the power supply voltage of the instrument cluster when the DTC was detected, and it is displayed in the M-MDS.
 VPWR (1)
IG-ON_TIMER hh:mm:ss (2) Elapsed time since ignition was switched ON (engine off or on)
NOTE:
  • The instrument cluster records the elapsed time since the ignition was switched ON (engine off or on).
  • The AWD CM constantly receives the elapsed time since the ignition was switched ON (engine off or on) sent via CAN signal from the instrument cluster.
  • If a DTC is detected, the AWD CM records the elapsed time since the ignition was switched ON (engine off or on) when the DTC was detected, and it is displayed in the M-MDS.
 -
PWR_MODE_KEY Key Out/Key Recently Out (Position 0)/Accessory (Position 1)/Post Ignition (Position 2)/Ignition On (Position 2)/Running (Position 2)/Running - Starting
  • Key Out: Ignition switched off
  • Key Recently Out (Position 0): Elapsed time within 3 s since ignition was switched off
  • Accessory (Position 1): Ignition is switched to ACC
  • Post Ignition (Position 2): Elapsed time within 3 s since ignition was switched ON (engine off or on)
  • Ignition On (Position 2): Ignition switched ON (engine off)
  • Running (Position 2): Ignition switched ON (engine on)
  • Running - Starting: Cranking condition
  • The AWD CM constantly receives the ignition switch status sent via CAN signal from the instrument cluster.
  • If a DTC is detected, the AWD CM records the ignition switch status when the DTC was detected, and it is displayed in the M-MDS.
 -
TOTAL_DIST km Miles Accumulated total traveled distance from completion of vehicle until AWD CM detects DTC (Odometer value in instrument cluster) The total traveled distance from which the AWD CM detects DTCs to the present can be calculated by performing the following procedure.
  1. Verify the odometer value in the instrument cluster.
  2. Verify the snapshot data item TOTAL_DIST.
  3. Subtract 2 from 1.
 -
TOTAL_TIME hh:mm:ss (2) Accumulated total elapsed time since vehicle completion until AWD CM detects a DTC
NOTE:
  • When the ROOM fuse is removed, and the ignition is switched off, the time is not included in the elapsed time.
 The elapsed time from which the AWD CM detects DTCs to the present can be calculated by performing the following procedure.
  1. Verify the instrument cluster PID item TOTAL_TIME.
  2. Verify the snapshot data item TOTAL_TIME.
  3. Subtract 2 from 1.
 TOTAL_TIME(1)
(1) Instrument cluster PID (See PID/DATA MONITOR TABLE [INSTRUMENT CLUSTER] .)

(2) The seconds may be indicated after the decimal point.
scientia non olet · About LEMON Manuals