CMDTC self test
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS (IDS) to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the IDS.
- Select "Self Test".
- Select "All CMDTCs".
NOTE:- Snapshot data appears at the top of the help screen when the displayed DTC is selected.
- Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the snapshot data.
- After completion of repairs, clear all DTCs stored in the AWD control module. (See CLEARING DTCS PROCEDURE .)