Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | VERIFY DTCs FOR TCM
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (FW6A-EL, FW6AX-EL)] .) |
| No | Go to the next step. | ||
| 2 | DRIVE VEHICLE THEN VERIFY DTCs FOR TCM AGAIN
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (FW6A-EL, FW6AX-EL)] .) |
| No | Go to the next step. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See ELECTRONIC AWD CONTROL SYSTEM ON-BOARD DIAGNOSIS [ELECTRONIC AWD CONTROL SYSTEM] .) |
| No | DTC troubleshooting completed. |