Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.

IAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	INSPECT FOR PCM MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the PCM. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5)] .)
1		No	Go to the next step.
2	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See ELECTRONIC AWD CONTROL SYSTEM ON-BOARD DIAGNOSIS [ELECTRONIC AWD CONTROL SYSTEM] .) Are the same DTCs present?	Yes	Replace the AWD CM. (See AWD CONTROL MODULE REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ELECTRONIC AWD CONTROL SYSTEM ON-BOARD DIAGNOSIS [ELECTRONIC AWD CONTROL SYSTEM] .)
3		No	DTC troubleshooting completed.