Diagnostic procedure
WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | SWITCH THE IGNITION TO OFF AND ALLOW AWD CM TO COOL DOWN. | ||
| 2 | VERIFY THAT THE SAME DTC IS NOT PRESENT
|
Yes | Replace the AWD CM. (See AWD CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY THAT NO OTHER DTCS ARE PRESENT
|
Yes | Go to the applicable DTC inspection. (See ELECTRONIC AWD CONTROL SYSTEM ON-BOARD DIAGNOSIS [ELECTRONIC AWD CONTROL SYSTEM] .) |
| No | DTC troubleshooting completed. | ||