Propeller Shaft Inspection

WARNING: This page is about a different variant/trim than selected.

Measure the propeller shaft center runout using the dial gauge.

Fig 1: Measuring Propeller Shaft Center Runout Using Dial Gauge
Courtesy of MAZDA MOTORS CORP.

Propeller shaft maximum runout

0.8 mm {0.031 in}
- If it exceeds the maximum specification, replace the propeller shaft as a single component. (See PROPELLER SHAFT REMOVAL/INSTALLATION .)
Inspect the play and rotation of the joint by turning the universal joint in the directions shown by the arrows.

Fig 2: Checking Propeller Shaft Rotation Torque
Courtesy of MAZDA MOTORS CORP.

Propeller shaft rotation torque

0.3-1.4 N.m {3.1-14.0 kgf.cm, 2.7-12.0 in.lbf}
- If it is not within the specification, replace the propeller shaft. (See PROPELLER SHAFT REMOVAL/INSTALLATION .)