LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Rear Differential) >> Rear Differential Removal/Installation >> Rear Differential Component Removal Note

Rear Differential Component Removal Note

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Always verify that the rear differential component is securely supported by a jack. If the rear differential component falls off, it can cause serious injury or death, and damage to the vehicle.
  1. Support the rear differential using a jack.
    Fig 1: Supporting Rear Differential Using Jack
    G09075053Courtesy of MAZDA MOTORS CORP.
  2. Loosen the differential mounting bracket bolt and rotate the bracket as shown in the figure.
    Fig 2: Rotating Differential Mounting Bracket
    G09075054Courtesy of MAZDA MOTORS CORP.
  3. Rotate the rear differential as shown in the figure, and then remove the rear differential.
Fig 3: Rotating Rear Differential
G09075055Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals