Rear Differential Mount Rubber, Bolt Installation Note

WARNING: This page is about a different variant/trim than selected.

Align the alignment marks on the rear crossmember and rear differential mount rubber, and install the rear differential mount rubber.

Fig 1: Placing Alignment Marks On Rear Crossmember And Rear Differential Mount Rubber
Courtesy of MAZDA MOTORS CORP.
NOTE:
- When newly replacing the rear differential mount rubber, place alignment marks on the new part in the same positions as the removed rear differential mount rubber.
Fig 2: Placing Alignment Marks On Rear Differential Mount Rubber
Courtesy of MAZDA MOTORS CORP.
Temporarily tighten bolts A and B.

Fig 3: Rear Differential Mount Rubber Bolts
Courtesy of MAZDA MOTORS CORP.
Remove the transmission jack.
Shake the rear differential forward and back/left and right to improve the installation fit of the rear differential.
Completely tighten bolts in the order of A and B.
Tightening torque

62-75 N.m {6.4-7.6 kgf.m, 46-55 ft.lbf}