LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Engine Mechanical System) >> Timing Chain Removal/Installation >> Cylinder Head Cover Removal Note

Cylinder Head Cover Removal Note

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the OCV connector.
  2. Remove the wiring harness clips secured to the cylinder head cover.
  3. Remove the wiring harness clip secured to the intake manifold as shown in the figure, and set the wiring harness aside.
    Fig 1: Removing Wiring Harness Clips
    G09785084Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the ventilation hose.
  5. Disconnect the brake vacuum hose from the intake manifold and set it aside.
  6. Remove the catch tank with the evaporative hose still connected and set it aside. (SKYACTIV-G 2.5) (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION .)
  7. Remove the cylinder head cover.
scientia non olet · About LEMON Manuals