LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Charging System - I-ELOOP) >> SERVICE PLUG DISCONNECTION/CONNECTION [i-ELOOP] >> Service Plug Disconnection/Connection

Service Plug Disconnection/Connection

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not get dust or oil on the service plug because it could increase the resistance in the capacitor (i-ELOOP).
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  2. Turn the steering wheel completely to the right.
  3. Remove the 3 fasteners for the front mudguard (LH) shown in the figure.
    Fig 1: Removing Fasteners For Front Mudguard (LH)
    G09784540Courtesy of MAZDA MOTORS CORP.
  4. Remove the service plug installation bolt shown in the figure.
    Fig 2: Locating Service Plug And Bolt
    G09784541Courtesy of MAZDA MOTORS CORP.
  5. Pull the service plug in the direction of the arrow shown in the figure.
    Fig 3: Pulling Service Plug
    G09784542Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • The service plug cannot be completely removed.
  6. Using the removed installation bolt, temporarily hold the service plug at the position to which it was pulled.
    Fig 4: Holding Service Plug Using Installation Bolt
    G09784543Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Tighten the bolt not using a tool but your hand so as not to strip the thread.
  7. Perform removal/installation of target i-ELOOP related parts.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals