LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Charging System - I-ELOOP) >> GENERATOR DISASSEMBLY/ASSEMBLY [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITH i-ELOOP)] >> Brush Assembly Note

Brush Assembly Note

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Melt the solder quickly, otherwise the diodes (rectifier) and regulator will be damaged by excessive heat.
Fig 1: Locating Soldered Area
G09784560Courtesy of MAZDA MOTORS CORP.
  1. Press the brush into the regulator component with it facing in the direction shown in the figure.
    Fig 2: Pressing Brush Into Regulator Component
    G11540336Courtesy of MAZDA MOTORS CORP.
  2. Solder the brush to the regulator component.
scientia non olet · About LEMON Manuals