LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Charging System - Engine) >> GENERATOR DISASSEMBLY/ASSEMBLY [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-ELOOP)] >> Brush Assembly Note

Brush Assembly Note

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Melt the solder quickly, otherwise the diodes (rectifier) and brush holder will be damaged by excessive heat.
Fig 1: Diodes (Rectifier) And Brush Holder Solder Area
G11450545Courtesy of MAZDA MOTORS CORP.
  1. Press the brush into the brush holder with it facing in the direction shown in the figure.
    Fig 2: Pressing Brush Into Brush Holder
    G11450547Courtesy of MAZDA MOTORS CORP.
  2. Solder the brush to the brush holder.
scientia non olet · About LEMON Manuals