LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (On-Board Diagnostic - Engine Controls (4 Of 4)) >> DTC U0074-00: Can System Communication Error (Local Can Between Pcm And TCM) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 VERIFY RELATED PENDING CODE AND/OR DTC 
Yes Go to the applicable PENDING CODE or DTC inspection.
(See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No Go to the next step.
3 VERIFY TCM DTC 
Yes DTC U0074:00 or U0115:00 is displayed:
  • CAN communication line can be considered the cause.

  • Repair or replace the wiring harness between PCM and TCM, then go to the next step.

DTC other than U0074:00 and U0115:00 is displayed:
No TCM can be considered the cause.
4 VERIFY DTC TROUBLESHOOTING COMPLETED 
Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE 
Yes Go to the applicable DTC inspection.
(See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No DTC troubleshooting completed.